Initiation Fault. Permanent Fault
Initiation fault. Permanent fault
Replacing the component
If there is an internal fault in the speed-dependent power steering, it should be replaced.
Replace speed-dependent power steering (stepper motor).
Additional information
- To access/replace stepper motor, see Stepper motor, steering gear, replacing Service and Repair
Continue - Verification
-------------------------------------------------
Verification
Verification
Hint: After the repair it is necessary to check that the fault has been rectified.
- Ignition off.
- Connect connectors, install components, etc.
- Start the engine.
Check that diagnostic trouble code status changes from permanent to intermittent.
Is the diagnostic trouble code status intermittent?
Yes - Verification completed
No - Trouble-shooting information
-------------------------------------------------
Trouble-shooting information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - Exit Fault-Tracing
No - Attempt New Test
------------------------
Attempt New Test - Replacing the component
-------------------------------------------------