Signal Faulty

Signal faulty

Replacing the component
Control unit has registered an internal fault.

Caution! A new control unit is supplied without software. The new control unit must be programmed before it will work. For information on programming and replacing the control unit, see Driver's door module / passenger door module (DDM/PDM), replacing Driver's Door Module/Passenger Door Module (DDM/PDM), Replacing.

After replacement of control unit it is necessary to set up the window position.
Move window to its upper turning position by manual operation.
Keep button pressed in to make sure that window is in the absolutely highest turning point and at the same time run a window position set-up.





Continue - FAULT FOUND

-------------------------------------------------