Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking wiring and connectors

Warning! Before fault-tracing can begin, the engine cooling fan (FC) connector must be disconnected to prevent the engine cooling fan (FC) engaging. Diagnostic trouble code (DTC) ECM-6120 Engine cooling fan (FC) control module may be stored. After fault-tracing the connector must be reconnected.

Check the signal cable between control module terminal #A4 (#A4) and engine coolant temperature (ECT) sensor terminal #1. Check for an intermittent short-circuit to ground.

Other information
- To connect the breakout box / access the control module, see Connecting the breakout box, B5254T2 Connecting the Test Box
- To access the engine coolant temperature (ECT) sensor, see Temperature sensor engine coolant, replacing Service and Repair
- For resistance values, see Component specifications Specifications
- For information about signals, see Signal specification Signal Specification
- Checking wiring and terminals Checking Wiring And Terminals.













Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Exit fault-tracing

------------------------

Attempt New Test - Checking wiring and connectors

-------------------------------------------------