Signal Too High / Signal Too Low. Permanent Fault

Signal too high / signal too low. Permanent fault

Replacing the component




- Ignition off.
The control module has registered an internal fault. Try a new control module according to Engine control module (ECM), replacing Service and Repair.

Note! When replacing a control module, new software must be programmed into the new control module.





Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Exit fault-tracing

------------------------

Attempt New Test - Replacing the component

-------------------------------------------------