Signal Too High. Intermittent Fault
Signal too high. Intermittent fault
Checking the control module
Check the relay coil driver circuit for an intermittent short-circuit to supply voltage by measuring the voltage between terminal #2 in the relay base and relay 2/112.
Hint: The voltage between terminal #2 and ground should be approximately 0 V.
Replace the control module if the voltmeter displays an incorrect value.
Other information:
- To access and replace the integrated relay / fusebox in the cargo compartment, see Integrated relay/fusebox cargo compartment/Rear electronic module (REM), replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing
- Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Continue - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).
Do you want to view the information again?
Yes - Attempt New Test
No - Exit fault-tracing
------------------------
Attempt New Test - Checking the control module
-------------------------------------------------