Signal Too High. Intermittent Fault
Signal too high. Intermittent fault
Checking the wires
Check the supply wire between the rear electronic module (REM) connector B20 ( D20) and the level sensor (ISM) connector 1 for an intermittent short circuit to voltage supply as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Additional information
- For information on signals and additional values, see Signal specification Signal Specification
- To connect the test box, see Connecting the breakout box Connecting Breakout Box, Rear Electronic Module (REM)
- To access rear electronic module (REM), see Integrated relay/fusebox cargo compartment/Rear electronic module (REM), replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing.
Continue - Trouble-shooting information
-------------------------------------------------
Trouble-shooting information
Information
Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).
Do you want to view the information again?
Yes - Attempt New Test
No - Exit fault-tracing
------------------------
Attempt New Test - Checking the wires
-------------------------------------------------