Signal Too High. Intermittent Fault
Signal too high. Intermittent fault
Checking the wires and components
Check that relay for "rear collapsible head restraint" (location 2/75) is correctly installed.
Check relay connection (2/75) for contact resistance and oxidation as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults , and for a loose contact as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Additional information:
- For information on signals and additional values, see Signal specification Signal Specification
- To connect the test box, see Connecting the breakout box Connecting Breakout Box, Rear Electronic Module (REM)
- To access the control unit, see Integrated relay/fusebox cargo compartment/Rear electronic module (REM), replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing
- When relay is installed and activated, relay control voltage ( 2) should be 0V.
Continue - Trouble-shooting information
-------------------------------------------------
Trouble-shooting information
Information
Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).
Do you want to view the information again?
Yes - Attempt New Test
No - Exit fault-tracing
------------------------
Attempt New Test - Checking the wires and components
-------------------------------------------------