Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking the wires and components
Check that relay for "Reversing lamp" (location 2/80) is correctly installed.
Check relay connection (2/80) for contact resistance and oxidation as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults , and for a loose contact as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.

Additional information:
- For information on signals and additional values, see Signal specification Signal Specification
- To connect the test box, see Connecting the breakout box Connecting Breakout Box, Rear Electronic Module (REM)
- To access rear electronic module (REM), see Integrated relay/fusebox cargo compartment/Rear electronic module (REM), replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing
- When relay is installed and activated, relay control voltage should be 0 V.









Continue - Trouble-shooting information

-------------------------------------------------

Trouble-shooting information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Exit fault-tracing

------------------------

Attempt New Test - Checking the wires and components

-------------------------------------------------