Signal Missing. Permanent Fault
Signal missing. Permanent fault
Checking the components
- Check that relay for "Reversing lamp" (location 2/80) is correctly installed.
- Do the necessary corrective action.
Activate the reversing lamps by pressing TO and FROM a few times.
Additional information:
- For information on signals and additional values, see Signal specification Signal Specification
- To access/replace the relay, see Integrated relay/fusebox cargo compartment/Rear electronic module (REM), replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing
- When relay is installed and not activated, relay control voltage should be 12 V.
Do the reversing lights work?
Yes - FAULT FOUND
No - Replacing the component
-------------------------------------------------
Replacing the component
Replace relay for "Reversing lamp" (location 2/80) and check relay connection, in particular the relay control (2/80 2), for an open circuit as described in Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Additional information:
- For information on signals and additional values, see Signal specification Signal Specification
- To access/replace the relay, see Integrated relay/fusebox cargo compartment/Rear electronic module (REM), replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing
- When relay is installed and not activated, relay control voltage should be 12 V.
Continue - Verification
-------------------------------------------------
Verification
Verification
Hint: After the repair it is necessary to check that the fault has been rectified.
- Ignition off.
- Install the components, connect the connectors, etc.
- Ignition on.
Activate reversing lamps.
Do the reversing lights work?
Yes - Verification completed
No - Trouble-shooting information
-------------------------------------------------
Trouble-shooting information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - Exit Fault-Tracing
No - Attempt New Test
------------------------
Attempt New Test - Checking the components
-------------------------------------------------