Signal Missing

Signal missing. Intermittent fault

Checking wiring and terminals
Check the wiring between the control module for the steering wheel angle sensor
terminal #1 (terminal (#A25) and steering wheel module (SWM) terminal #6 (terminal #A6)
terminal #8 (terminal (#A32) and steering wheel module (SWM) terminal #7 (terminal #A7)
terminal #9 (terminal (#A33) and steering wheel module (SWM) terminal #12 (terminal #A12)
check for contact resistance and oxidation. Check for an intermittent open-circuit.

Other information:
- To connect the breakout box to the control module for the steering wheel angle sensor, see Connecting the breakout box to the steering angle sensor Connecting the Breakout Box
- To connect the breakout box to the steering wheel module (SWM), see Connecting the breakout box Connecting the Breakout Box
- To replace the steering wheel angle sensor, see Contact reel / steering wheel angle sensor, replacing Contact Reel / Steering Wheel Angle Sensor, Replacing
- For information about signals to the control module for the steering wheel angle sensor, see Signal description, Control unit for the steering wheel angle sensor (SAS)
- For information about signals to the steering wheel module (SWM), see Signal specification Signal Specification, Steering Wheel Module (SWM)
- Checking wiring and terminals Checking Wiring And Terminals









Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Exit fault-tracing

------------------------

Attempt New Test - Checking wiring and terminals

-------------------------------------------------