Signal Too High

Signal too high. Permanent fault

Checking the connected battery charger and starter unit

Note! When a battery charger or a starter unit has been connected to the battery it is important to check that the proper voltage has been set. Charging with too high a voltage may cause a diagnostic trouble code to be stored.

Check that the battery charger/starter unit is connected and that the correct voltage is set.
Check the charging system for too high a charging voltage.
Do the necessary corrective action.





Select Continue when the fault has been rectified.

Continue - Verification

-------------------------------------------------

Trouble-shooting information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the connected battery charger and starter unit

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the components, reconnect the connectors etc.
- Test drive the car according to Test driving Test Driving
- Ignition on.
Read off the status of the diagnostic trouble code (DTC).









Is the status intermittent?

Yes - Verification completed

No - Trouble-shooting information

-------------------------------------------------