Activated Too Long. Permanent Fault
Activated too long. Permanent fault
Checking the control
Check that the control does not stick in the activated position.
Replace the turn signal lamp switch.
Remedy as necessary.
Other information:
- To replace the turn signal lamp switch, see Turn signal switch, replacing Service and Repair
Select "Continue" when the fault has been remedied.
Continue - Verification
-------------------------------------------------
Verification
Verification
Hint: After the repair it is necessary to check that the fault has been rectified.
- Ignition off.
- Connect the connectors, install the components, etc.
- Ignition on.
Check that all indicator switch functions work.
Does switch work?
Yes - Verification completed
No - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - Exit Fault-Tracing
No - Attempt New Test
------------------------
Attempt New Test - Checking the control
-------------------------------------------------