Invalid Combination. Permanent Fault
Invalid combination. Permanent fault
Checking the turn signal lamp switch
Replace the turn signal lamp switch because an internal fault has been found.
Other information:
- To replace the turn signal lamp switch, see Turn signal switch, replacing Service and Repair.
Select "Continue" when the fault has been remedied.
Continue - Verification
-------------------------------------------------
Verification
Verification
Hint: After the repair it is necessary to check that the fault has been rectified.
- Ignition off.
- Connect the connectors, install the components, etc.
- Ignition on.
Check that all indicator switch functions work.
Does switch work?
Yes - Verification completed
No - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - Exit Fault-Tracing
No - Attempt New Test
------------------------
Attempt New Test - Checking the turn signal lamp switch
-------------------------------------------------