Accessory Electronic Module Without Wiring Kit

Accessory Electronic Module without wiring kit







- Turn the ignition key to position 0
- Cars with manual gearboxes: Remove the ignition key
- Disconnect the battery negative lead.

NOTE: Wait at least five minutes before disassembling the connectors or removing other electrical equipment.







- Fold up the rear section of the cargo compartment carpet
- Press the centre of the clips at the lower edge of the foldable side panel on the left-hand side until they click
- Remove the two clips.







- Turn the handle (1) on the right-hand side through 90�.
- Fold down the side panel down. Lift the panels out.







- Install the new bracket on the right-hand rear side member.
- Install and tighten the bracket parallel with the side member. Use the screw and the nut from the kit
- Tighten to 10 Nm (8 lbf ft)
- Drill a Dia 4 mm (5/32 inches) hole in the side member, through the front hole in the bracket
- Tighten the front mounting for the bracket to the side member. Use a self tapping screw from the kit
- Remove any swarf.







Applies to cars equipped with a Diversity antenna amplifier
- Wrap foam tape around the cable/wiring for the antenna amplifier.

Applies to all models
- Remove the pre-routed cable for the accessory electronic module. The cable is taped up at the rear edge of the right-hand rear wheel well
- Take the accessory electronic module from the kit. Connect the routed cable to the cable illustrated.







- Press the control module onto the bracket by the side member.







- Slacken off the rear screw (1) in the bracket for the accessory electronic module a few turns
- Insert the grooved end of the lock facing (2) under the screw head. Position as illustrated
- Tighten the screw. Tighten to 10 Nm (8 lbf. ft.)
- Reinstall the removed panel in the cargo compartment.







- Install the fuse from the kit in position 11 in the fuse holder.







- Turn the ignition key to position II
- Reconnect the battery negative lead
- Reinstall the cargo compartment carpet
- Reinstall both floor hatches
- Program the software.