Checking Control of the Power Door mirror

Checking control of the power door mirror

Checking the connectors




- Ignition off
- Check the power door mirror connector and connectors 54/10 and 54/11. Check for contact resistance and oxidation
- Ignition on.
Check that the power door mirror can be operated.

Other information:
- To access the connector for the power door mirror, see Door mirror, replacing Door Mirror, Replacing
- Checking wiring and terminals Checking Wiring And Terminals.





Do the door mirror controls operate?

Yes - FAULT FOUND

No - Checking components and wiring

-------------------------------------------------

Checking components and wiring
Check the cable between control module terminal #5B and ground: Left or right seat support. Check for an open-circuit.
If a fault is found replace the cable.
If no fault is found replace the power door mirror.

Other information:
- For further information about signals and other values, see Signal specification Signal Specification, Driver Door Module (DDM) / Passenger Door Module (PDM)
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box
- To access and replace the power door mirror, see Door mirror, replacing Door Mirror, Replacing
- Checking wiring and terminals Checking Wiring And Terminals.





Continue - FAULT FOUND

-------------------------------------------------