Sunroof / Moonroof: Adjustments

Sun roof, adjusting

Height adjustment
Close the sun roof.
Remove the apron molding according to Apron molding .
Slacken off the screws for the glass cover according to Glass cover .





Front edge:
The upper section of the molding must be flush with or 1 mm under the roof panel (Dimension A).

Rear edge:
The upper section of the molding must be flush with or 1 mm above the roof panel (Dimension B).
Calibrate according to Sun roof module (SRM), calibrating Programming and Relearning.
Tighten the screws.

Adjusting sideways and front-rear
Remove the headlining according to Headlining, replacing Headlining, Replacing




Remove the 8 screws.
There are two reference holes. One is round and the other is oval.
Lift up the sun roof.
Insert a drift that matches the diameter of the hole
Adjust the sunroof so that it is level at the sides and has even pressure at the front and rear edges.
Test the function of the sun roof by opening and closing it as far as it will go.
Calibrate according to Sun roof module (SRM), calibrating Programming and Relearning.