Replacing the Oil Pump

Replacing the oil pump

Removal

Removing the transmission side cover
Remove the side cover. See Removing gearbox side cover Removing Gearbox Side Cover.

Removing oil pump





Note! In order to replace the lock-up solenoid, the oil pump must be removed from the control system. This is so that the spring clip holding the solenoid can be accessed. The shiny screw (1) must not be removed, it holds the oil pump together.

Remove:
- the temperature sensor with the cable harness from the clip
- the connector from the solenoid. Fold the cable harness out of the way
- the screws,notthe shiny screws (1).

Note! The dimension of the upper screws.

Removing the oil pump from the pump shaft




Pull it straight out.
Place the pump on clean paper.

Installation

Installing the oil pump





Note! Ensure that mating surfaces are clean.

Note! Use lint free paper.

Lift and turn the pump slightly so that it is centered on the pump shaft.
Finger-tighten the screws. The two upper screw heads (206) are sized 10 mm. The other screw heads (207) are 8 mm.
First tighten the screws crosswise to light contact.
Tighten the upper screws. Tighten to 16 Nm. Tighten the other screws. Tighten to 12 Nm.

Installing the side cover on the transmission
Install the side cover. See Installing the gearbox side cover Installing the Gearbox Side Cover.

Filling with transmission fluid
Fill with transmission fluid. See Transmission oil / oil filter, replacing Removal and Replacement.
Test drive the car.