Oil Level Sensor: Service and Repair

Oil level sensor, replacing

Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential information in the illustrations is always correct.

Removal and Installation

Removing the oil level sensor

Warning! Hot oil can scald. Avoid skin contact with engine oil, particularly if the engine oil is dirty. Immediately wash hands and any skin that has been in contact with oil. Use a suitable cleaning agent and warm water. Wear protective gloves when working with engine oil.

Remove the splash guard under the engine. Only applies to cars with automatic transmissions.
Position the container under the engine oil trough.
Remove the oil plug.
Drain the engine oil. It is easier to drain the oil if the engine is at operating temperature.





Remove:
- the screws for the sensor. Disconnect the connector for the sensor
- the sensor.

Installing the oil level sensor

Note! For tightening torques, see Tightening torque Tightening Torque.





Install:
- the sensor
- screws for the sensor. Tighten. Connect the connector to the sensor
- the oil plug.

Finishing
Fill with engine oil. Run the engine to operating temperature. Check for any oil leakage.
Install the splashguard under the engine. Only applies to cars with automatic transmissions.
Check the oil level. Top up if required.