Checking Control Module connection

Checking control module connection

Checking control module connection




- Ignition off.
Check that control module connector is correctly connected to control module and that connector lock is working.
Check that control module connector, pins and socket housings are not damaged.





Is the control module correctly connected?

Yes - fault not found

No - control module connection

-------------------------------------------------

Corrective action, control module connection
Connect control module.


Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition off.
- Reconnect connectors, reinstall components.
- Ignition on.
When the ignition is switched on the control module lights the ABS warning lamp. Check that the warning lamp goes out after approximately 2 seconds.

Note! The warning lamp will not go out if a fault has been stored in the control module.





Does the ABS warning lamp light and go out shortly afterwards?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should be diagnosed and remedied. Since this is not the case the fault-tracing process has failed.
Complete the fault-tracing for those fault or try again.

Do you want to terminate fault-tracing at this time?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking control module connection

-------------------------------------------------