Switch For the Sensor Shut Off Function

Switch For The Sensor Shut Off Function

NOTE: This accessory is connected to the car's electrical system. It requires software unique to the car.

Preparations







- Turn the ignition key to position 0
- Cars with manual gearboxes: Remove the ignition key
- Disconnect the battery negative lead.

NOTE: Wait at least five minutes before disassembling the connectors or removing other electrical equipment.







- Carefully pry off the panel in front of the gear selector lever. Use a plastic weatherstrip tool.
- Move the gear selector lever as far back as possible.







- Remove the two screws from the dashboard environment panel.







- Pull the panel (1) with the boot as far backwards as possible. Turn the panel.
- Remove the screws (2) from the dashboard environment panel (3).







- Carefully angle the dashboard environment panel out using a plastic weatherstrip tool so that it is possible to insert a couple of fingers to gain access to the side of the dashboard environmental panel
- Remove the dashboard environment panel. Pull it downward, maintaining the same angle.
- Disconnect the connectors on the reverse of the dashboard environment panel.

Note: If any of the outer hooks break off, these must be repaired.







- Remove the cigarette lighter
- Position the dashboard environmental panel
- Detach the surround (1) by carefully pushing down the three catches (2) in the holes (3) using a small screwdriver. At the same time pry out the surround using a thin weatherstrip tool. Starting at the 12 volt socket (4), pry up one corner. The surround is tightly secured so take care not to damage any components
- Remove the surround.

Installation







- Remove the switch blank. Install the new switch (1)
- Reinstall the surround and the cigarette lighter
- Connect the connectors to the dashboard environment panel. Reinstall the dashboard environment panel
- Reinstall the panel in front of the gear selector lever, alternatively the panel with the boot.

Finishing work







- Turn the ignition key to position II
- Reconnect the battery negative lead
- Program the software.