Backup Lamp: Service and Repair

Adapter Cable, Reversing Warning System







- Remove the lower grey six pin connector in the left-hand tail lamp. Push in the catches on the lower edge. Pull the connector out.
- Connect the connector (1) disconnected from the Left tail lamp to the adapter cable connector (2)







- Connect the adapter cable connector (3) to the left-hand tail lamp.
- Install a cable connector (1) between the red (R) cable from the switch and the red cable from the control module
- Install a cable connector (2) between the pink (P) adapter cable and the remaining red cable from the switch







- Install a cable connector (3) between the black (SB) adapter cable and the black cable from the control module.