Checking the Interior Lighting (2)

Checking the interior lighting (2)

Checking the interior lighting
Two times can be programmed for the interior lighting:

1. Short
- The period from when the door is unlocked, or the engine stops, to when the interior lighting goes out can be changed if it is too long or too short.

2. Long
- The period from when the door is opened, or a lamp is lit with a switch, to when the lamp goes out can be changed if it is too long or too short.
To program a long interior lighting period you must step ("click") through the short interior lighting period programming.

Continue - Programming a short interior lighting period

-------------------------------------------------

Programming a short interior lighting period
The general lighting and rear reading lamps light and remain lit for 30 seconds when:
- The door has been unlocked from outside with a key or the remote control.
- The engine has been stopped and the ignition key turned to 0.
The default period is 30 seconds. This can be changed to between 5 and 255 seconds.
Read off the programmed values.
To change the time, mark the desired value in the scrolling list and start programming.





Do you want to program any more parameters?

Yes - Programming a long interior lighting period

No - Fault Found

-------------------------------------------------

Programming a long interior lighting period
The general lighting and rear reading lamps light and remain lit for 10 minutes when:
- A door is opened after being unlocked.
- The lamp is lit with a switch.
The default period is 10 minutes. This can be changed to between 0 and 255 minutes at 10 minute intervals.
Read off the programmed values.
To change the time, mark the desired value in the scrolling list and start programming.





Continue - Fault Found

-------------------------------------------------