Fog Lamp Protectors

Fog lamp protectors


















Fog lamp protectors

Note! Carry out all procedures in these instructions on both the left and right-hand sides of the car.




- Clean the lens of the fog lamps and the surrounding surfaces. Wipe dry.




- Position the fog lamp protector (see the marking on the top edge) over the cut out for the fog lamp in the bumper cover as illustrated.

Caution! Ensure that the fog lamp protector is positioned correctly over the cut out so that the markings for the clip positions are correct.

- Mark out the position for the clips using a piece of tape or similar on the bumper cover. The clips must be positioned opposite the centres of the holes in the fog lamp protector on the right and left-hand sides as illustrated
- Remove the fog lamp protector.




- Take two clips and two plastic nuts from the kit. Press the plastic nuts into the clips.




- Remove the backing from the clips
- Insert the clips at the tape markings in the gap between the fog lamp protectors and the bumper cover. Ensure that the tape on the clips does not catch on the bumper cover. If necessary use a plastic weatherstrip tool to widen the gap
- Align the clips at the tape markings. Press the clips securely into the bumper cover.




- Remove the two tape markings
- Install the two screws. Tighten the fog lamp protector.

Maintenance instructions
- To maintain a good beam of light, regularly remove the fog lamp protectors for cleaning. Also clean the fog lamps.

Caution! Do not use a strong cleaning agent which may have an etching effect on the fog lamp protector.