Checking the Front position Lamps

Checking the front position lamps

Checking the wiring and the relay
Check the signal cables to the parking lamps. Check for an open-circuit. Check for contact resistance and oxidation.
Check the relay (2/61).

Hint: The voltage over the relay must be 12 V on pins #1 and #3 when the parking lamp is switched on.

Check the cable between terminal #3 and fuse 2, main fuses in the engine compartment (11A/2).
Also check the main fuse.
Check the connector between (54/3R).
Check the cable between the relay #1 (2/61) and passenger compartment fuses for the left respectively right parking lamps. (Fuse 11C/30 for the left side and 11C/31 for the right side).
Check the cable between the passenger compartment fuse and terminal #2 of the lamp housing for the relevant lamp circuit.
For the left parking lamp, check lamp 10/11.
For the right parking lamp, check lamp 10/12.
Check the ground supply between the lamp housing terminal #1 and the ground terminal.
Also check the connector between (54/3L).
Remedy as necessary.

Other information
- To access or replace the headlamp, see Headlamp/bulb, replacing Headlamp/Bulb, Replacing
- Checking wiring and terminals Checking Wiring And Terminals.









Continue - Fault Found

-------------------------------------------------