Campaign - Radio/CD Player Replacement
S60/V70 (01-)/V70 XC (01-)/S802001-2002
Section
3
Group
39
No.
0040
Year
03
Month
11
Service Campaign No.123B
Exchange unit radio/CD player HU-80X
Background
Under certain circumstances, the main flat cable from the CD player mechanism may chafe, causing erratic functionality. The corrective action will be to replace the radio and re-route the location of the flat cable.
Competence Level
Volvo Level 2 Technician
Affected vehicle
Model
S60/V70 (01-)/V70 XC (01-) 2001-2002
S80 2002
Material
Description Quantity Software Product
S80
Exchange unit HU-801 1 8103208
SW Radio HU-801 (US) 1 9438269
V70 (01-), V70 XC (01-)
Exchange unit HU-803 1 8103209
SW Radio HU-803 (US) 1 9488841
S60
Exchange unit HU-803 1 8103209
SW Radio HU-803 (US) 1 8633563
Equipment for entertainment (radio/TV/VCR)
Exchange unit radio/CD player; replace
Reading the serial number 1
Read the serial number off the radio/CD player. See VADIS:
Vehicle communication
Function group 3
Reading off the control module ID.
Replacing the radio/CD player 2
If the serial number of the radio/CD player is between 010727000000 - 011014999999, the radio/CD player must be replaced with a replacement unit.
The first digits in the serial number are a date code:
YYMMDD, Y = Year M = Month D = Day
(011005000058 = 2001, October, 05)
Removing the radio/CD player 3
Remove all CDs from the radio/CD player.
Do not open the radio/CD player or use force to eject the CDs.
To replace the radio/CD player, see VADIS:
Repair and installation
Function group 39
Radio/carphone (Radio cassette player), replacing.
Keep the radio/CD player in the same position as it was originally installed in the vehicle (at an angle of 15-20 degrees). See illustration (A).
Set the CD mechanism to its default mode:
Switch on the ignition.
Disconnect the green connector from the radio/CD player and wait 5 seconds.
Reconnect the green connector to the radio/CD player.
The CD player will now turn to its default mode.
Wait until there is no sound from the CD mechanism. Disconnect all the connectors. Remove the radio/CD player.
Installing transportation screws on removed radio/CD players 4
Install the warning decal on the radio/CD player.
Move the transportation screws and clips at the rear edge from the exchange unit to the removed unit.
Tighten the screws. Tighten to 4 Nm.
Secure the decal on the reverse of the radio/CD player (1). Use tape.
Note!
The transportation screws must not be installed if the CD player does not return to its default mode.
Installing the radio/CD player 5
When connecting, it is important that the radio/CD player is in the same position as it was originally installed in the car (at an angle of 15-20 degrees). See the illustration (A).
Connect all the connectors.
Install the radio/CD player according to the method in VADIS.
Test the functionality 6
Note!
The old radio/CD player must be returned immediately using the standard replacement routines.