DTC 22-1X

DTC 22-1x (22-10 to 22-19, 22-1A to 22-1F): Open or Increase Resistance in Front Passenger's Seat Belt Tensioner

Special Tools Required
- SRS inflator simulator 07SAZ-TB4011A
- SRS simulator lead C 07TAZ-SZ5011A
- SRS simulator lead F 07XAZ-SZ30l00

1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes oft.

Does the SRS indicator stay on, and is DTC 22-1x indicated?

YES - Go to step 3.

NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, go to the DTC troubleshooting index.

3. Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.




4. Disconnect the front passenger's seat belt tensioner 2P connector from the SRS right side subharness (A).
5. Connect the SRS inflator simulator (2 Ohm connectors) and simulator lead C to the SRS right side subharness.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Check for a DTC.

Is DTC 22-1x indicated?

YES - Go to step 9.

NO - Open or increased resistance in the front passenger's seat belt tensioner; replace the front passenger's seat belt.

9. Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.




10. Disconnect SRS left side subharness 4P connector C806 (A) from the SRS right side subharness 4P connector C806 (B).
11. Connect the SRS inflator simulator (2 Ohm connectors) and simulator lead F to the SRS left side subharness 4P connector C806.
12. Reconnect the battery negative cable.
13. Erase the DTC memory.
14. Check for a DTC.

Is DTC 22-1x indicated?

YES - Go to step 15.

NO - Open or increased resistance in the SRS right side subharness; replace the SRS right side subharness.

15. Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.




16. Disconnect the driver's seat belt tensioner connector (A).
17. Disconnect SRS unit connector B (28P) from the SRS unit. Do not disconnect the special tool from the SRS left side subharness 2P connector.




18. Check resistance between the No.3 and No.4 terminals of SRS unit connector B (28P). There should be 2.0 - 3.0 Ohm.

Is the resistance as specified?

YES - Faulty SRS unit or poor contact at SRS unit connector B (28P) and the SRS unit. Check the connection; if the connection is OK, replace the SRS unit.

NO - Go to step 19.




19. Disconnect SRS left side subharness 28P connector C803 (A) from the SRS main subharness connector C803 (B).




20. Check resistance between the No.3 and the No.4 terminals of the SRS left side subharness 28P connector C 803. There should be 2.0 - 3.0 Ohm.

Is the resistance as specified?

YES - Open or increased resistance in the SRS main subharness; replace the SRS main subharness.

NO - Open or increased resistance in the SRS left side subharness; replace the SRS left side subharness.