DTC 34-1x

DTC 34-1x (34-10 to 34-19, 34-1A to 34-1F): Open or Increased Resistance in Right Side Curtain Airbag Inflator

Special Tools Required
- SRS inflator simulator 07SAZ-TB4011A
- SRS simulator lead E 07XAZ-S1A0200
- SRS simulator lead F 07XAZ-SZ30100

1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

Does the SRS indicator stay on, and is DTC 34- lx indicated?

YES - Go to step 3.

NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, go to the DTC troubleshooting index.

3. Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.




4. Disconnect the roof wire harness 2P connector (A) from the right side curtain airbag 2P connector (B).
5. Connect the SRS inflator simulator (2 Ohm connector) and the simulator lead E to the roof wire harness.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Check for a DTC.

Is DTC 34-1x indicated?

YES - Go to step 9.

NO - Open or increased resistance in the right side curtain airbag inflator, replace the right side curtain airbag.

9. Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.




10. Disconnect roof wire harness 4P connector C812 (A) from the SRS main harness 4P connector.
11. Connect the SRS inflator simulator (2 Ohm connectors) and simulator lead F to the SRS main harness.
12. Reconnect the battery negative cable.
13. Erase the DTC memory.
14. Check for a DTC.

Is DTC 34-1x indicated?

YES - Go to step 15.

NO - Open or increased resistance in the roof wire harness; replace the roof wire harness.

15. Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.
16. Disconnect SRS unit connector C (16P) from the SRS unit.
17. Disconnect the special tool from the SRS main harness 4P connector.




18. Check resistance between the No.3 and No.4 terminals of the SRS main harness 4P connector. There should be 1.0 Ohm or less.

Is the resistance as specified?

YES - Faulty SRS unit or poor contact at SRS unit connector B (28P) and the SRS unit. Check the connection; if the connection is OK, replace the SRS unit.

NO - Go to step 19.




19. Disconnect the SRS main subharness 28P connector (A) from the SRS main harness C801 (B).




20. Check resistance between the No.5 and No.6 terminals of the SRS main subharness 28P connector C801. There should be 1.0 Ohm or less.

Is the resistance as specified?

YES - Open or increased resistance in the SRS main harness; replace the SRS main harness.

NO - Open or increased resistance in the SRS main subharness; replace the SRS main subharness.