B1169

DTC B1168: Gauge Control Module Lost Communication with the PCM (Engine Messages)

DTC B1169: Gauge Control Module Lost Communication with the PCM (A/T Messages)

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A.

1. Clear the DTCs using the HDS.
2. Turn the ignition switch OFF, and then back ON (II).
3. Start and run the engine for at least 5 seconds then turn the engine off.
4. Check for DTCs with the HDS.

Is DTC B1168 or B1169 indicated?

YES - Go to step 5.

NO - Intermittent failure, the F-CAN communication line is OK at this time. Check for loose or poor connections. If the connections are good, check the battery condition, and the charging system.

5. Check for DTCs in the PCM with the HDS.

Are any DTCs indicated?

YES - Troubleshoot the PCM DTCs.

NO - Go to step 6.

6. Turn the ignition switch OFF.
7. Jump the SCS line with the HDS.
8. Disconnect the gauge control module 36P connector.
9. Disconnect PCM connector A (44P).




10. Check for continuity between the No. 28 and No. 29 terminals of the gauge control module 36P connector and the A36 and A44 terminals of the PCM connector A (44P) A36 and A37 respectively.

Is there continuity?

YES - Go to step 11.

NO - Repair an open in the wire between the gauge control module and the PCM.

11. Substitute a known-good gauge control module and reset.
12. Check for DTCs with the HDS.

Is DTCs B1168 or B1169 indicated?

YES - Replace the PCM.

NO - Replace the original gauge control module.