DTC 14

DTC 12, 14, 16, 18: Wheel Sensor (Electrical Noise/Intermittent Interruption)

NOTE: If the ABS and other indicators come on because of electrical noise, the indicators will go off when you test-drive the vehicle speed at 10 mph (15 km/h) or more and noise is gone.

1. Check the appropriate wheel sensor and magnetic encoder on the front wheel bearing or magnetic encoder on the rear hub bearing unit.





Are they installed correctly and in good condition?

YES-Go to step 2.

NO-Reinstall or replace the appropriate wheel sensor, front wheel bearing, or rear hub bearing unit, and recheck by test-driving.

2. Substitute an appropriate known-good wheel sensor.
3. Turn the ignition switch ON (II).
4. Clear the DTC with the HDS
5. Test-drive the vehicle at 10 mph (15 km/h) or more.
6. Check for DTCs with the HDS

Is DTCs 12, 14, 16, and/or 18 indicated?

YES-Go to step 7.

NO-Replace the original wheel sensor.

7. Substitute an appropriate known-good front wheel bearing, or rear hub bearing unit.
8. Clear the DTC with the HDS.
9. Test-drive the vehicle speed at 10 mph (15 km/h) or more.
10. Check for DTCs with the HDS

Is DTCs 12, 14, 16, and/or 18 indicated?

YES-Check for loose terminals in the VSA modulator-control unit 46P connector. If necessary, substitute a known-good VSA modulator-control unit and retest.

NO-Replace the original front wheel bearing or rear hub bearing unit:
^ Front: Replace the front wheel bearing.
^ Rear: Replace the rear hub bearing unit.