B1231

DTC B1231 or DTC indicator G and AUTO: An Open in the Evaporator Temperature Sensor Circuit

1. Clear the DTC with the HDS.
2. Turn the ignition switch to LOCK (0), and then ON (II).
3. Do the self-diagnostic with the HDS or climate control unit.
4. Check for DTCs.

Is DTC B1231 or G and AUTO indicated?

YES - Go to step 5.

NO - Intermittent failure, check for loose wires or poor connections on the evaporator temperature sensor circuits.

5. Turn the ignition switch to LOCK (0).
6. Test the evaporator temperature sensor.

Is the evaporator temperature sensor OK?

YES - Go to step 7.

NO - Replace the evaporator temperature sensor.

7. Disconnect the climate control unit connector A (24P).
8. Check for continuity between the climate control unit connector A (24P) No. 13 terminal and the evaporator temperature sensor 2P connector No. 2 terminal.






Is there continuity?

YES - Go to step 9.

NO - Repair open in the wire between the climate control unit and the evaporator temperature sensor.

9. Check for continuity between the climate control unit connector A (24P) No. 18 terminal and the evaporator temperature sensor 2P connector No. 1 terminal.






Is there continuity?

YES - Check for loose wires or poor connections at the climate control unit connector A (24P) and at the evaporator temperature sensor 2P connector. If the connections are good, substitute a known-good climate control unit, and recheck. If the symptom/indication goes away, replace the original climate control unit.

NO - Repair open in the wire between the climate control unit and the evaporator temperature sensor.