Operation CHARM: Car repair manuals for everyone.
Home >> Acura Truck >> 2009 >> RDX L4-2.3L Turbo >> Repair and Diagnosis >> Restraints and Safety Systems >> Relays and Modules - Restraints and Safety Systems >> Air Bag Control Module >> Service and Repair >> ODS Unit Replacement

ODS Unit Replacement




ODS Unit Replacement

Removal

1. Do the battery terminal disconnection procedure Procedures, then wait for 3 minutes before starting work.

2. Disconnect the passenger's side airbag 2P connector. Service and Repair

3. Remove the passenger's seat assembly: '09 model Front Seat Removal/Installation and seat-back cover '09 model. Front Seat-back Cover/Pad Replacement

4. Remove the cover (A), then disconnect the sensor connectors (B), from the ODS unit (C) and ODS unit 18P connector ('07-08 models) or front passenger's seat wire harness 18P connector ('09 model) (D).

5. Remove the two screws (E) and the ODS unit.






Installation

1. Place the new ODS unit (A) on the seat-back frame. Tighten the two screws (B), and connect the sensor connectors (C) and ODS unit 18P connector ('07-08 models) or front passenger's seat wire harness 18P connector ('09 model) (D) to the ODS unit. Reinstall the cover (E).

2. Install the seat-back cover in the reverse order of removal.

3. Install the seat assembly: '09 model Front Seat Removal/Installation, then connect the side airbag 2P connector.

4. Do the battery terminal reconnection procedure. Procedures

5. Set the seat-back in the normal position, and make sure there is nothing on the front passenger's seat.

6. Initialize the ODS unit. ODS Unit Initialization

7. After installing the ODS unit, confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.





pro multis · About Operation CHARM