Removal and Replacement

Starter Removal and Installation

Removal

1. Do the battery terminal disconnection procedure Procedures.

2. Remove the front bumper Front Bumper.

3. Remove the clip (A), then remove the coolant reservoir (B) from the holder.






4. Remove the support rod clamp bracket (A).






5. Disconnect the A/C condenser fan motor connector (A), then remove the A/C condenser fan shroud assembly (B).






6. Remove the harness clamp (A) and the connector (B), then remove the intake manifold bracket (C).






7. Disconnect the starter cable (A) from the B terminal, then disconnect the connector (B) from the S terminal.





8. Remove the harness clamps (C), then remove the starter.

Installation

1. Install the starter, then install the starter cable (A) and connector (B). Make sure the starter cable crimped side of the ring terminal faces away from the starter when you connect it.





2. Install the harness clamps (C).

3. Install the intake manifold bracket (A), then install the harness clamp (B) and connector (C).






4. Install the A/C condenser fan shroud assembly (A), then connect the A/C condenser fan motor connector (B).






5. Install the support rod clamp bracket (A).






6. Install the coolant reservoir.






7. Install the front bumper Front Bumper.

8. Do the battery terminal reconnection procedure Procedures.

9. Start the engine to make sure the starter works properly.