B1032

DTC Troubleshooting: B1032

DTC B1032:

MICU Lost Communication With SRS Unit (CDS message)

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A Troubleshooting - B-CAN System Diagnosis Test Mode A.

1. Clear the DTCs with the HDS.

2. Turn the ignition switch to LOCK (0), and then back to ON (II).

3. Wait for at least 6 seconds or more.

4. Check for DTCs with the HDS.

Is DTC B1032 indicated?

YES -

Go to step 5.

NO -

Intermittent failure, the gauge control module is OK at this time. Check for loose or poor connections at the gauge control module 36P connector and at under-dash fuse/relay box connector Q (16P). If the connections are good, check the battery condition Testing and Inspection and the charging system.�

5. Check for DTCs with the HDS.

Are DTCs B1008 and B1011 also indicated with DTC B1032?

YES -

Check for an open or high resistance in the communication circuit between the MICU and the gauge control module. If the circuit is faulty, repair the open or high resistance. If the circuit is OK, faulty MICU, replace the under-dash fuse/relay box Under-Dash Fuse/Relay Box Removal/Installation.�

NO -

Go to the gauge control module input test Component Tests and General Diagnostics.�