82-11

SRS DTC Troubleshooting: 82-11

DTC 82-11:

No Signal From the Inner Side Front Passenger's Weight Sensor

NOTE:

- Before doing this troubleshooting procedure review SRS Precautions and Procedures Service and Repair and General Troubleshooting Information Reading and Clearing Diagnostic Trouble Codes and Battery Terminal Disconnection and Reconnection Procedures.

- These SWS DTCs are cleared by turning the ignition switch to LOCK(0).

1. Clear the DTCs with the HDS.

2. Turn the ignition switch to ON (II), then wait for 10 seconds.

3. Check for DTCs with the HDS.

Is DTC 82-11 indicated?

YES -

Go to step 4.

NO -

Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.�

4. From the HDS Main Menu, select SRS, then Inspection. In the Inspection Menu, select SWS DTC CHECK.

Is an SWS DTC also indicated?

YES -

- DTC 11-11: Short to power in the inner side front passenger's weight sensor power circuit. Go to step 5.
- DTC 11-12: Short to ground in the inner side front passenger's weight sensor output circuit. Go to step 11.

NO -

Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.�

5. Turn the ignition switch to LOCK (0).

6. Disconnect the ODS unit harness 2P connector (A) from the inner side front passenger's weight sensor (B).





7. Turn the ignition switch to ON (II), then wait for 10 seconds.

8. Clear the DTCs with the HDS.

9. Turn the ignition switch to ON (II), then wait for 10 seconds.

10. From the HDS Main Menu, select SRS, then Inspection. In the Inspection Menu, select SWS DTC CHECK.

Is SWS DTC 11-11 indicated?

YES -

Short to power in the ODS unit harness; replace the ODS unit harness, then clear the DTC. If the DTC does not clear, replace the ODS unit ODS Unit Replacement.�

NO -

Faulty inner side front passenger's weight sensor; replace the inner side front passenger's weight sensor Service and Repair, then clear the DTC.�

11. Turn the ignition switch to LOCK (0).

12. Disconnect the ODS unit harness 2P connector (A) from the inner side front passenger's weight sensor (B).





13. Turn the ignition switch to ON (II), then wait for 10 seconds.

14. Clear the DTCs with the HDS.

15. Turn the ignition switch to LOCK (0), then wait for 10 seconds.

16. Turn the ignition switch to ON (II), then wait for 10 seconds.

17. From the HDS Main Menu, select SRS, then Inspection. In the Inspection Menu, select SWS DTC CHECK.

Is SWS DTC 11-12 indicated?

YES -

Go to step 18.

NO -

Faulty inner side front passenger's weight sensor; replace the inner side front passenger's weight sensor Service and Repair, then clear the DTC.�

18. Turn the ignition switch to LOCK (0).

19. Measure the resistance between body ground and ODS unit harness 2P connector terminal No. 2. There should be an open circuit or at least 1 MOhms.





Is the resistance as specified?

YES -

Faulty ODS unit; replace the ODS unit ODS Unit Replacement, then clear the DTC.�

NO -

Short to ground in the ODS unit harness; replace the ODS unit harness, then clear the DTC.�