Audio-Navigation Unit Removal/Installation

Audio-Navigation Unit Removal/Installation

SRS components are located in this area. Review the SRS component locations Locations, and the precautions and procedures Service and Repair before doing repairs or service.

NOTE:

- Put on gloves to protect your hands.
- Take care not to scratch the dashboard and related parts.
- Lay a workshop towel under the parts when working on them to protect the face panel from scratches or other damage.
- Eject all the discs before remove the audio-navigation unit to prevent damaging the CD player's load mechanism.
- If you are replacing the audio-navigation unit, write down the audio presets (if possible), and enter them into the new audio-navigation unit.

1. Make sure you have the anti-theft codes for the audio-navigation unit.

2. Remove the driver's inner dashboard trim Driver's Inner Dashboard Trim Removal/Installation, and the passenger's dashboard trim Passenger's Dashboard Trim Removal/Installation.

3. Remove the console lower trim (A) and the bolts (B), then pull out the audio-navigation unit (C).





4. Disconnect the connectors (D), then remove the audio-navigation unit.

5. Remove the climate control unit Climate Control Unit Removal/Installation.

6. Remove the bolts (A) and the radio brackets (B).





7. Remove the screws and audio-navigation unit (C) from the audio-navigation panel (D).

8. Remove the interface dial Service and Repair.

9. Install the audio-navigation unit in the reverse order of removal.

NOTE:

- If you are replacing the audio-navigation unit, remove the HDD HDD Removal/Installation.
- Check any official Honda service website for more service information about patches for the navigation system. Apply any prescribed patches to the new audio-navigation unit.

10. Enter the new audio-navigation unit anti-theft codes.

11. Park the vehicle outside, and do the GPS initialization.

12. Give the new anti-theft codes to the client.