Center Console Rear Trim Removal/Installation

Center Console Rear Trim Removal/Installation

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program, 888-424-6857

NOTE:

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- Take care not to scratch the center console or the related parts.

1. Starting at the top, gently pull out the console rear trim (A) to detach the clips (B), then pull out the trim to detach the remaining clips (C), and to release the lower tabs (D), disconnect the connectors, then remove the trim:

- Rear heater-A/C passenger's control panel-unit connector (E)
- With second row seat heater: Second row seat heater switch connectors (F)
- Without rear entertainment: Accessory power socket connector (G)
- With rear entertainment: RES auxiliary jack assembly connector (G)





2. Install the trim in the reverse order of removal, and note these items:

- Make sure all connectors are plugged in properly.
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.