B1836

DTC Troubleshooting: B1836

DTC B1836:

Power Seat Position Sensor Circuit Short

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A Troubleshooting - B-CAN System Diagnosis Test Mode A.

1. Clear the DTCs with the HDS.

2. Turn the ignition switch to LOCK (0) and then back to ON (II).

3. Operate the power seat adjustment switch in all directions for more than 2 seconds each.

4. Check for DTCs with the HDS.

Is DTC B1836 indicated?

YES -

Go to step 5.

NO -

Intermittent failure, the system is OK at this time. Check for loose or poor connections.

5. Turn the ignition switch to LOCK (0).

6. Disconnect power seat control unit connector A (40P).

7. Disconnect the 5P connector from each motor.

8. Check for continuity between power seat control unit connector A (40P) terminal No. 15 and body ground.





Is there continuity?

YES -

Repair a short to ground in the wire.

NO -

Go to step 9.

9. Check for continuity between slide motor/position sensor 5P connector terminal No. 2 and body ground (motor body).





Is there continuity?

YES -

Replace the slide motor/position sensor Front Seat Frame Replacement - Driver's Seat.

NO -

Go to step 10.

10. Check for continuity between body ground (motor body) and terminal No. 3 of the front up-down motor/position sensor, rear up-down motor/position sensor, and recline motor/position sensor.





Is there continuity?

YES -

Faulty the motor/position sensor, replace the seat frame assembly Front Seat Frame Replacement - Driver's Seat.

NO -

Replace the power seat control unit Testing and Inspection.