Seat Position Sensor: Service and Repair

Driver's Seat Position Sensor Replacement

Removal

NOTE:

- Removal of the driver's seat position sensor must be done according to Precautions and Procedures Service and Repair.
- Do not turn the ignition switch to ON (II), and do not connect the battery cable while removing the driver's seat position sensor.

1. Raise the driver's seat all the way up.

2. Do the battery terminal disconnection procedure Procedures, then wait at least 3 minutes before starting work.

3. Remove the upper rail inner cover.

4. Disconnect the driver's seat wire harness 2P connector (A) from the driver's seat position sensor (B).





5. Remove the TORX bolt (C) using a TORX T30 bit and nut (D), then remove the driver's seat position sensor.

Installation

NOTE:

- Be sure to install the harness so it does not pinched or interferes with other parts.
- Do not turn the ignition switch to ON (II) and do not connect the battery cable while installing the driver's seat position sensor.

1. Install the driver's seat position sensor with a new TORX bolts (A) and new nut (B).





2. Connect the driver's seat wire harness 2P connector (C) to the driver's seat position sensor (D).

3. Do the battery terminal reconnection procedure Procedures.

4. Clear any DTCs with the HDS.

5. Check the operation of the driver's seat position sensor with the HDS Testing and Inspection.

6. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

7. Reinstall all removed parts.