DTC 13-3

DTC 13-3: No signal from the driver's side impact sensor

1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds, and then goes off.

Does the SRS indicator stay on?

YES - Go to step 3.

NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures.

3. Disconnect the battery negative cable, and wait for 3 minutes.
4. Check the connection between the SRS floor harness 4P connector and the driver's side impact sensor.

Is the connections OK?

YES - Faulty SRS floor harness or driver's side impact sensor; replace the SRS floor harness. If the problem is still present, replace the driver's side impact sensor.

NO - Poor contact between the SRS floor harness 4P connector and the driver's side impact sensor; reconnect or replace the sensor.