DTC 2-4

DTC 2-4: Short to power in passenger's airbag inflator

1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds.and then goes off.

Does the SRS indicator stay on?

YES - Go to step 3.

NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures.

3. Disconnect the battery negative cable, and wait for 3 minutes.




4. Disconnect the front passenger's airbag 4P connector from the SRS main harness 4P connector (A).
5. Connect the special tool (2 Ohm) to the SRS main harness 2P connector.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.

Is DTC 2-4 indicated?

YES - Go to step 9.

NO - Short to power in the front passenger's airbag inflator; replace the front passenger's airbag.

9. Disconnect the battery negative cable, and wait for 3 minutes.




10. Disconnect the driver's airbag 2P connector (A) from the cable reel 2P connector (B), and disconnect the special tool (2 Ohm) from the SRS main harness 4P connector.




11. Disconnect the SRS main harness 18P connector (A) from the SRS unit (B).
12. Reconnect the battery negative cable.
13. Turn the ignition switch ON (II).




14. Check for voltage between the No. 6 terminal of the SRS main harness 18P connector and body ground, the No. 15 terminal and body ground, the No. 5 terminal and body ground, and the No. 14 terminal and body ground. There should be 0.5 V or less.

Is the voltage as specified?

YES - Faulty SRS unit; replace the SRS unit.

NO - Short to power in the SRS main harness; replace the SRS main harness.