P0798

DTC P0798: Premium

NOTE: Record all freeze data and review General Troubleshooting Information before you troubleshoot.

1. Disconnect the 2P connector from A/T clutch pressure control solenoid valve C.





2. Measure A/T clutch pressure control solenoid resistance at the solenoid valve connector.
Is the resistance about 5 ohms ?
YES-Go to step 3.
NO-Replace A/T clutch pressure control solenoid valve C.
3. Disconnect PCM connector B (25P).





4. Check for continuity between body ground and PCM connector terminals B13 and B24 individually.
Is there continuity?
YES-Repair short to ground in the wires between PCM connector terminals B13, B24 and A/T clutch pressure control solenoid valve C.
NO-Go to step 5.
5. Connect the A/T clutch pressure control solenoid valve C connector.





6. Measure the resistance between PCM connector terminals B13 and B24.
Is the resistance about 5 ohms ?
YES-Go to step 7.
NO-Repair loose terminal or open in the wires between PCM connector terminals B13, B24 and ACT clutch pressure control solenoid valve C.
7. Disconnect PCM connector D (16P).
8. Turn the ignition switch ON (II).





9. Measure the voltage between PCM connector terminals D5 and B20 or B22.
Is there battery voltage?
YES-Check for loose terminal fit in PCM connectors B13, B24 and D5. If necessary, substitute a known-good PCM and rechecks
NO-Check for blown No. 6 (15A) fuse in the driver's under-dash fuse/relay box. If the fuse is OK, repair open in the wire between PCM connector terminals D5 and the driver's under-dash fuse/relay box, and between B20, B22 and ground (G101).