P1298
DTC P1298: ELD Circuit High Voltage1. Reset the PCM.
2. Start the engine.
3. Turn on the headlights.
Is DTC P1298 indicated?
YES - Go to step 4.
NO - Intermittent failure, system is OK at this time. Check for poor connections or loose wires at the ELD, and the PCM.
4. Turn the ignition switch and headlights OFF.
5. Disconnect the ELD 3P connector.
6. Turn the ignition switch ON (II).
7. Measure voltage between body ground and ELD 3P connector terminal No.1.
Is there battery voltage?
YES - Go to step 8.
NO - Repair open in the wire between the No.6 ECU (PCM) CRUISE CONTROL (15 A) fuse and the ELD.
8. Turn the ignition switch OFF.
9. Connect ELD 3P connector terminal No.3 to body ground with a jumper wire.
10. Disconnect PCM connector A (32P).
11. Check for continuity between body ground and PCM connector terminal A30.
Is there continuity?
YES - Go to step 12.
NO - Repair open in the wire between the PCM (A30) and the ELD.
12. Check for continuity between ELD 3P connector terminal No.2 and body ground.
Is there continuity?
YES - Go to step 10.
NO - Repair open in the wire between the ELD and G201.
13. Reconnect the ELD 3P connector and PCM connector A (32P).
14. Start the engine and let it idle.
15. While measuring voltage between PCM connector terminals A30 and B20, turn the headlights on (high).
Does the voltage drop?
YES - Substitute a known-good PCM and recheck. If the symptom/indication goes away, replace the original PCM.
NO - Replace the ELD.