DTC 65

DTC 65: Brake Fluid Level
1. Check the brake fluid level.
Is the level correct?
YES - Go to step 2.
NO - Check the brake system for leaks. If no leaks are found, replace the worn out brake pads if needed.
2. Disconnect the gauge control module connector A (30P), and brake fluid level switch 2P connector.





3. Check for continuity between terminal No. 2 of the gauge control module connector A (30P) and body ground.
Is there continuity?
YES - Repair short to ground in the GRN/RED wire between the gauge control module and the brake fluid level switch.
NO - Go to step 4.
4. Check the brake fluid level switch.
Is the switch OK?
YES - Do the self-diagnostic function troubleshooting for the gauge control module.
NO - Replace the brake fluid level switch.