DTC 14-2

DTC 14-1, 14-2: Lateral/Longitudinal Acceleration Sensor Neutral Position

NOTE: Before you troubleshoot, review the general troubleshooting information.

1. Turn the ignition switch ON (II).
2. Make sure the HDS communicates with the vehicle and the SH-AWD control unit. If it doesn't, troubleshoot the DLC circuit.
3. Clear the DTC with the HDS.
4. Start the engine.
5. Check for DTCs with the HDS.

Is DTC 14-1 and/or 14-2 indicated?

YES - Go to step 6.

NO - Intermittent failure, the system is OK at this time.

6. Place the vehicle on a flat surface.
7. Check the lateral/longitudinal acceleration sensor A/D value in the DATA LIST with the HDS.

Is there about 2.2 - 2.8 V?

YES - Go to step 8.

NO - Check the yaw rate-lateral/longitudinal acceleration sensor installation.

8. Check for yaw rate-lateral/longitudinal acceleration neutral position memorization with the HDS.

Is the value "OK"?

YES - Replace the SH-AWD control unit.

NO - Do the yaw rate-lateral/longitudinal acceleration neutral position memorization. Neutral Position Memorization