DTC 82-3

DTC 82-3: Right Search Coil Sensor Magnetic Flux Characteristic

NOTE: Before you troubleshoot, review the general troubleshooting information.

1. Turn the ignition switch ON (II).
2. Make sure the HDS communicates with the vehicle and the SH-AWD control unit. If it doesn't, troubleshoot the DLC circuit.
3. Turn the ignition switch OFF.
4. Disconnect SH-AWD control unit connector A (26P).
5. Measure the resistance between SH-AWD control unit connector terminals A6 and A19.





Is there 2.0 Ohms or less?

YES - Replace the rear differential side case.

NO - Go to step 6.

6. Clear the DTC with the HDS.
7. Do the SH-AWD differential clutch torque memorization.
8. Test-drive the vehicle at a speed of more than 1 mph (2 km/h) for at least 1 second.
9. Check for DTCs with the HDS.

Is DTC 81-1, 81-2, 82-1, and/or 82-2 indicated?

YES - Go to the indicated DTC's troubleshooting.

NO - Intermittent failure, the system is OK at this time.