Operation CHARM: Car repair manuals for everyone.

Driver's Power Seat Motor Test




Driver's Power Seat Motor Test

NOTE: SRS components are located in this area. Review the SRS component locations Locations, and the precautions and procedures Service and Repair before doing repairs or servicing.

Slide motor, Front up-down motor, Rear up-down motor

1. Remove the driver's seat Front Seat Removal / Installation.

2. Disconnect the connector from each power seat motor.






3. Test each motor by connecting power and ground according to the table. When the motor stops running, disconnect battery power immediately.





4. If the motor does not run or fails to run smoothly, replace it:

- Slide motor Front Seat Slide Motor Replacement
- Front up-down motor Front Seat Up-Down Motor Replacement
- Rear up-down motor

Recline motor

1. Remove the driver's seat-back cover Service and Repair.

2. Disconnect the 5P connector from the recline motor.






3. Test the motor by connecting power and ground according to the table. When the motor stops running, disconnect battery power immediately.





4. If the motor does not run or fails to run smoothly, replace the recline motor Front Seat Recline Motor Replacement.