Transfer Assembly Fluid Inspection and Replacement (M/T)

Transfer Assembly Fluid Inspection and Replacement

1. Raise the vehicle on a lift, and make sure it is supported securely.

2. Remove the filler plug (A) and the sealing washer (B), check the condition of the transfer fluid, and make sure it is at the proper level (C).






3. If the transfer fluid is dirty, remove the drain plug (A) and the sealing washer (B), drain the transfer fluid.






4. Refill the transfer assembly with the recommended fluid (hypoid gear oil) through the filler plug hole until the fluid flows out. Use an SAE 90 viscosity hypoid gear oil, API classified GL4 or GL5 only.






Transfer Fluid (Hypoid Gear Oil) Capacity:





5. Install the filler plug with a new sealing washer.