Transfer Assembly Installation (A/T)

Transfer Assembly Installation

1. Clean the areas where the transfer assembly contacts the transmission with solvent, and dry with compressed air. Then apply transmission fluid to the contact area.

2. Install the dowel pin (A) in the transmission, and install the transfer assembly (B) on the transmission.






3. Install the No. 1 propeller shaft (A) to the transfer companion flange (B) by aligning the reference mark (C).






4. Secure the transfer breather tube bracket (A) on the transfer assembly with the bolt, and install the breather tube (B) over the breather pipe (C). Align the tube at the dot mark (D) facing the rear of the vehicle.






5. Install exhaust pipe A with the new self-locking nuts and new gaskets (B) (C).






6. Install the front subframe stiffener with new mounting bolts.





7. Refill the transfer assembly with the transfer fluid (hypoid gear oil), if necessary Transfer Assembly Fluid Replacement (A/T).

8. Move the shift lever to P.

9. Refill the transmission with ATF.