Accessory Control Display: Service and Repair

Interface Dial Removal/Installation

1. Remove the audio-navigation switch panel Audio-Navigation Switch Panel Removal/Installation.

2. Remove the screw and harness cover (A).






3. Disconnect the interface dial connector (A). Remove the screws and interface dial (B). Carefully pry off the knob (C) with a small screwdriver, then apply slow and steady pressure with your thumbs to push out the interface dial until the dial (D) pops off.





4. Install the dial in the reverse order of removal.

NOTE: If the hard buttons do not work, but the jog dial does, recheck the interface dial connector connection.