Side Airbag Replacement

Side Airbag Replacement

NOTE: If replacing the side airbag after deployment, refer to Component Replacement/Inspection After Deployment Service and Repair for a complete list of other parts that must also be replaced.

Removal

1. Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.

2. Remove the front seat Front Seat Removal/Installation.

3. Remove the seat-back cover/pad Front Seat-Back Cover Replacement.

4. Detach the harness clip (A) from the seat frame. Remove the two mounting nuts (B), then remove the side airbag (C).






Installation

NOTE:

- If the side airbag lid is secured with tape, remove the tape.
- Do not open the lid on the side airbag cover.
- If you are replacing a deployed airbag, replace the attachment wire A, B, and C.
- Make sure that the seat-back cover/pad is installed properly. Improper installation may prevent proper deployment.
- Be sure to install the harness so that they are not pinched or interfering with other parts.

1. Place the side airbag (A) on the seat-back frame. Tighten the new mounting nuts (B) to the specified torque.





2. Install the harness clip (C).

3. Install the seat-back cover/pad Front Seat-Back Cover Replacement.

4. Install the front seat Front Seat Removal/Installation.

5. Do the battery terminal reconnection procedure.

6. Move the front seat and the seat-back through their full ranges of movement, making sure the harness wires are not pinched or interfering with other parts.

7. Clear any DTCs with the HDS.

8. After installing the side airbag, confirm proper system operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.